Glock Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
Well took my new unfired 21/4 apart and noticed the ejector pin was bent more than normal,tried to straighten it out but I busted it so I ordered the trigger block from Brownells,no big deal. I would like to replace the trigger bar with a GEN3 while I have the thing apart. What part do I order,is the 21/4 compatible with 21SF's?If somebody knows exactly what I need and where to order from I'd appreciate it.
 

·
Registered
Joined
·
2,109 Posts
If I remember correctly there was a post on the forum already discussing the transfer of trigger bar across models, as in what will work and what will not. I believe most are transferable across models but you may want to search for it to be sure.
 

·
Registered
Joined
·
21,518 Posts
1 - 3 of 3 Posts
Top