Glock Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Last night I was replacing the trigger on my block 23. During the replacement I accidentally snapped the bottom corner off of the trigger housing. The part that I am referencing is the bottom pointy part which sets into the pistol grip. I am thinking the only functionality this part served was to hold the trigger housing in place in relation to the rear trigger pin on the pistol grip. Since there is still one corner in place to retain the trigger pin do I have anything to be worried about?
 

·
Registered
Joined
·
2,109 Posts
Yes, post some picks. But if anything with the trigger is broken then you should replace it, there should be no question there. Your life may depend on it. Glock parts are inexpensive. If you contact Glock they may even send you one if you describe your problem.
 

·
Registered
Joined
·
4,767 Posts
You probably have it fixed by now...

Back when you posted, I believe you had ordered a new housing and spring...did that take care of it? :confused:
 
1 - 4 of 4 Posts
Top