Glock Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I want to convert g23 to shoot out of my g32
I have ten round mags that jams with 357
In them.i have put new 357 # 1 followers in them
And still won't work, will I still have the same problem with preban
Mags?i would hate to buy them and not have them work..
Any thoughts would be great
Thanks
 

·
Registered
Joined
·
3,865 Posts
I dont know that the followers were different in preban mags or not. Give it a try.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #4 ·
I have a glock 32,stock.i live in ma and bought
It used.it came with 10 glock23 mags and they don't work.
I bought glock 32 mags(10 rds) and they work fine.
But to set it up to a high cap,I have to run preban 23 mags.
I'm trying to find out if thoughs will work..
 

·
Registered
Joined
·
1,292 Posts
Why preban G23 mags? Was the G32 made after the ban so there are no prebans?

I'm not sure why the G23 mags don't work (assume they're preban?). Guess I know why you don't want to just buy one and test as I've heard the preban mags are quite a bit more expensive.
 

·
Registered
Joined
·
4 Posts
Discussion Starter · #6 ·
There's no preban.....I dont know a lot about glocks just yet.
But the 40 mags look different.they have to slot in both sides on the front.they jam the round
On the backside the round under the top one slips in the the groove on the
Back and won't let the round out.I have to push the round underneath down to get the top one
Out.I tryed putting a 357 follower in the 40 mag and it didn't make a differents.worst case I could buy the prebans and if they
Don't work I could sell them or buy a 40 barrel.
It would just be cool to get it working on a sort of hard to find gun in ma
 

·
Registered
Joined
·
3,865 Posts
I'm confused, but good luck. I have never had any trouble using 40 cal and 357 auto mags interchangeably.
 
1 - 8 of 8 Posts
Top