Joined
·
2 Posts
Hello to everyone, yesterday I purchased my second glock, the first one was a 19x.
On the G26 I'm having jamming problems and after some investigation I noticed that the G26 is 1mm higher on this part of the slide than the 19x and beside the obvious total length difference the other measurement are equal. And seeing how the bullets are marked, I think that there's a fabrication mistake there.
I was wondering if anyone with a G26 gen 5 could measure their so I could compare it to mine to si if that's the actual problem. Thanks
The ammo used was my own reloads and I never had a single jam on my 19x
![Office supplies Wood Trigger Air gun Electric blue]()
![Gas Automotive exterior Bumper Cable Metal]()
![Ruler Finger Office ruler Wood Font]()
![Finger Gesture Ruler Rectangle Font]()
![Water Musical instrument Hood Audio equipment Eyewear]()
![Musical instrument accessory Wood Electronic instrument Bumper Automotive exterior]()
![Finger Wood Household hardware Gas Thumb]()
![Finger Thumb Nail Electric blue Automotive tire]()
![Gun accessory Gun barrel Composite material Trigger Thumb]()
Enviado desde mi SM-A525M mediante Tapatalk
On the G26 I'm having jamming problems and after some investigation I noticed that the G26 is 1mm higher on this part of the slide than the 19x and beside the obvious total length difference the other measurement are equal. And seeing how the bullets are marked, I think that there's a fabrication mistake there.
I was wondering if anyone with a G26 gen 5 could measure their so I could compare it to mine to si if that's the actual problem. Thanks
The ammo used was my own reloads and I never had a single jam on my 19x
Enviado desde mi SM-A525M mediante Tapatalk
