Glock Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
hi sirs. i hope im in the right thread... just wondering if its possible to mill a g19 slide to fit a g23 barrel?
i have an extra g19 slide and want to convert it to .40 cal... has anyone tried doing this?
thanks in advance :D
 

·
Registered
Joined
·
2,284 Posts
I believe you would have to do lot of work to get the slide milled correctly! I think it would be both easier and more cost-effective to simply purchase a G-23 slide from lone wolf distributors!
 

·
Registered
Joined
·
12 Posts
Discussion Starter #3
I believe you would have to do lot of work to get the slide milled correctly! I think it would be both easier and more cost-effective to simply purchase a G-23 slide from lone wolf distributors!
I wish it was that easy... Where im from it would cost me 500 ++dollars/ 20-25k in pesos.... Not only that, slides are dificult to find :(
 
1 - 4 of 4 Posts
Top