Glock Forum banner
1 - 3 of 3 Posts

· Registered
15 Posts
Discussion Starter · #1 ·

Roughing out the pattern for a strike plate on a Glock. This is just a first step, and it looks like a meat tenderizer at this point. Anyhow it goes on the end of a glock so you can press it against a surface without pusing the slide out of battery or hit/break glass without damaging the crown.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.